A4 Mk2
| Removing and installing sealing flanges and dual-mass flywheel |
Note| Servicing clutch → Rep. Gr.30 |
| 1 - | 15 Nm |
| 2 - | Oil seal |
| q | Renewing → Chapter |
| q | Do not lubricate with oil |
| 3 - | Sealing flange (front) |
| q | Must be positioned on dowel sleeves |
| q | Removing and installing → Chapter |
| q | Install using sealant; sealant → Parts catalogue |
| 4 - | Cylinder block |
| q | Removing and installing crankshaft → Chapter |
| q | Dismantling and assembling pistons and conrods → Chapter |
| 5 - | Securing bolt for dual-mass flywheel |
| q | Renew |
| q | Tightening torque → Anchor |
| 6 - | Dual-mass flywheel |
| q | Removing and installing → Chapter |
| 7 - | Intermediate plate |
| q | Must be positioned on dowel sleeves |
| q | Do not damage/bend when assembling |
| q | Is fitted on sealing flange → Fig. |
| 8 - | 15 Nm |
| 9 - | Sealing flange (rear) with oil seal |
| q | Renew only as complete unit → Chapter |
| q | Use guide sleeve provided when fitting |
| q | Do not lubricate/grease sealing lip of oil seal |
| q | Before installing, remove oil remains from crankshaft journal with a clean cloth |
| q | Guide sleeve is not to be removed until sealing flange has been slipped onto crankshaft journal |
|
|
