A4 Mk2
Note
|
| 1 - | 15 Nm |
| 2 - | Oil seal |
| q | Renewing → Chapter |
| q | Do not lubricate with oil |
| 3 - | Sealing flange (front) |
| q | Must be positioned on dowel sleeves |
| q | Removing and installing → Chapter |
| q | Install using sealant; sealant → Parts catalogue |
| 4 - | Cylinder block |
| q | Removing and installing crankshaft → Chapter |
| q | Dismantling and assembling pistons and conrods → Chapter |
| 5 - | Securing bolt for flywheel/dual-mass flywheel/drive plate |
| q | Renew |
| q | Tightening torque for dual-mass flywheel → Anchor |
| q | Tightening torque for flywheel → Anchor |
| q | Tightening torque for drive plate → Anchor |
| 6 - | Flywheel/dual-mass flywheel/drive plate |
| q | Removing and installing dual-mass flywheel on vehicles with manual gearbox → Chapter |
| q | Removing and installing flywheel on vehicles with multitronic gearbox → Chapter |
| q | Removing and installing drive plate on vehicles with automatic gearbox 01V → Chapter |
| 7 - | Intermediate plate |
| q | Must be positioned on dowel sleeves |
| q | Do not damage/bend when assembling |
| q | Is fitted onto sealing flange → Fig. |
| 8 - | 15 Nm |
| 9 - | Sealing flange (rear) with oil seal |
| q | Renew only as complete unit → Chapter |
| q | Use guide sleeve provided when fitting |
| q | Do not lubricate/grease sealing lip of oil seal |
| q | Before installing, remove oil residue from crankshaft journal with a clean cloth |
| q | Guide sleeve is not to be removed until sealing flange has been slipped onto crankshaft journal |
|
|
