audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Installing a new balance shaft assembly > < Removing and installing oil pump

A4 Mk2

Removing balance shaft assembly
Removing balance shaft assembly
Special tools and workshop equipment required
   
t  Diesel injection pump locking pin -3359-
  W00-0306
Procedure
–  Remove sump → Chapter.
–  Lever off cover cap from vibration damper.
–  Turn the crankshaft to TDC.
l  The space between the two lugs -1- on sender wheel of camshaft must align with marking “4Z”-item 2- on toothed belt cover (rear).
  Note
For illustration purposes, the camshaft sprocket is shown with the toothed belt removed.
–  Lock hub with locking pin -3359-.
–  Unscrew bolts in the sequence shown by the numbers and remove balance shaft assembly with oil pump:
  A13-0349
t  Balance shaft assembly with eight attachment points.
  A13-10207
t  Balance shaft assembly with six attachment points.
  Note
t  Installing a new balance shaft assembly → Chapter.
t  Re-installing the "old" balance shaft assembly → Chapter.
  A17-10650

Installing a new balance shaft assembly > < Removing and installing oil pump