audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Extracting and driving in needle bearing for crankshaft - needle bearing (closed version) > < Removing and installing sender wheel for engine speed sender G28

A4 Mk2

Extracting and driving in needle bearing for crankshaft - needle bearing (open version)
Extracting and driving in needle bearing for crankshaft - needle bearing (open version)
  Note
A needle bearing must be fitted in the crankshaft on vehicles with manual gearbox; insert needle bearing if not yet fitted.
Special tools and workshop equipment required
   
t  Drift -VW 207 C- or centring mandrel -3176-
  W00-0369
t  -1- Internal puller Kukko 21/1
t  -4- Counter-support Kukko 22/1
t  Depth gauge
  W00-0633
Procedure
l  Gearbox removed.
–  Remove clutch pressure plate → Rep. Gr.30.
–  Remove needle bearing using internal puller Kukko 21/1 and counter-support Kukko 22/1.
  A13-0227
–  Drive needle bearing into crankshaft using drift -VW 207 C- or centring drift -3176-.
  V13-0446
Installation depth of needle bearing
l  Dimension -a- = 1.5 mm
–  Install clutch pressure plate → Rep. Gr.30.
  V13-0428

Extracting and driving in needle bearing for crankshaft - needle bearing (closed version) > < Removing and installing sender wheel for engine speed sender G28