A4 Mk2
Poly V-belt drive for air conditioner - exploded view |
1 - | Bracket |
2 - | Air conditioner compressor |
WARNING
|
q | After removing compressor from mountings, secure it to longitudinal member with wire or similar. Do not leave it suspended from refrigerant pipes. |
q | Do not unscrew or disconnect refrigerant hoses or pipes. |
q | Removing and installing → Rep. Gr.87 |
3 - | Dowel sleeve |
q | Check for correct seating in bracket |
4 - | 25 Nm |
5 - | Bracket for air conditioner compressor |
6 - | Tensioning roller for poly V-belt |
q | Removing and installing → Chapter „Removing and installing poly V-belt“ |
7 - | Washer |
8 - | 25 Nm |
9 - | Poly V-belt |
q | Check for wear |
q | Before removing, mark direction of rotation with chalk or felt-tipped pen. If the belt runs in the opposite direction when it is refitted, this can cause breakage. |
q | Removing and installing → Chapter |
q | When installing, make sure it is properly seated on pulleys. |
q | Routing of poly V-belt → |
10 - | Washer |
11 - | 25 Nm |
q | Property class 10.9; use only genuine bolts (same as original equipment) → Electronic parts catalogue |
12 - | Retaining clamp |
13 - | 10 Nm |
Routing of poly V-belt |
1 - | Air conditioner compressor |
2 - | Tensioning roller for poly V-belt |
3 - | Pulley for viscous fan |
4 - | Alternator |
5 - | Poly V-belt |
q | For alternator, power steering pump and viscous fan |
6 - | Power steering pump |
7 - | Vibration damper |
8 - | Tensioner for poly V-belt |
q | For AC compressor |
9 - | Poly V-belt |
q | For AC compressor |