audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing sealing flange (rear) > < Removing and installing dual-mass flywheel - vehicles with manual gearbox

A4 Mk2

Removing and installing flywheel - vehicles with multitronic gearbox
Removing and installing flywheel - vehicles with multitronic gearbox
Special tools and workshop equipment required
   
t  Counterhold tool -10 - 201-
  W00-0254
Removing
l  Engine or gearbox removed.
–  Remove damper unit -arrow- → Rep. Gr.13.
  A13-0821
–  Mark installation position of flywheel -arrow- on crankshaft.
–  Attach counter-hold tool -10 - 201- in order to loosen bolts.
–  Unbolt flywheel.
Installing
Installation is carried out in the reverse order; note the following:
–  Use new securing bolts.
–  Reverse position of counterhold tool -10 - 201- in order to tighten bolts.
–  Install damper unit → Rep. Gr.13.
Tightening torque
  A13-0822
ComponentNm
Flywheel to crankshaft 
 Bolt length 22.5 mm60 + 90° 1)
l  1) Renew bolts.

   

Removing and installing sealing flange (rear) > < Removing and installing dual-mass flywheel - vehicles with manual gearbox