Audi Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Exhaust gas recirculation system (engine codes AVB, AVF and AWX) >
< Removing and installing temperature sender after particulate filter G527 - vehicles with manual gearbox
A4 Mk2
Power unit
4-cylinder TDI unit injector engine (1.9 ltr.; 2.0 ltr. 2-valve), mechanics
Exhaust system
Exhaust gas temperature control
Removing and installing temperature sender after particulate filter G527 - vehicles with multitronic gearbox
Removing and installing temperature sender after particulate filterG527 - vehicles with multitronic gearbox
Removing and installing temperature sender after particulate filter -G527- - vehicles with multitronic gearbox
Removing
–
Remove front exhaust pipe
→ Chapter
.
–
Unscrew temperature sender after particulate filter -G527-
-arrow-
.
Installing
Installation is carried out in the reverse order; note the following:
–
When installing, make sure that temperature sender after particulate filter -G527- is fitted at angle
-α-
.
l
Angle
-α-
= 30° ± 5°
–
Route electrical wiring as shown in illustration.
1 -
Cable tie on engine wiring harness
2 -
Cable tie on gearbox
–
Install front exhaust pipe
→ Chapter
.
Tightening torque
Component
Nm
Temperature sender after particulate filter -G527- to front exhaust pipe
45
1)
l
1)
Coat with high-temperature paste; for high-temperature paste refer to
→ Electronic parts catalogue
Power unit
4-cylinder TDI unit injector engine (1.9 ltr.; 2.0 ltr. 2-valve), mechanics
Exhaust system
Exhaust gas temperature control
Removing and installing temperature sender after particulate filter G527 - vehicles with multitronic gearbox
Exhaust gas recirculation system (engine codes AVB, AVF and AWX) >
< Removing and installing temperature sender after particulate filter G527 - vehicles with manual gearbox