A4 Mk2
Valve gear - exploded view |
1 - | Bracket for wiring -10 Nm- |
2 - | 20 Nm |
q | Note sequence for loosening and tightening → Chapter „Removing and installing camshafts“ |
3 - | Rocker arm shaft |
4 - | Bolt for rocker arm shaft |
q | Renew |
q | Note correct sequence when loosening → Anchor |
q | Note correct sequence when tightening → Anchor |
5 - | Cylinder head bolt |
q | Renew |
q | Note correct sequence when loosening → Anchor |
q | Note correct sequence when tightening → Anchor |
6 - | Washer |
q | For cylinder head bolts |
q | Insert in cylinder head before installing bearing frame |
7 - | Valve cotters |
8 - | Valve spring plate |
9 - | Valve spring |
10 - | Valve stem oil seal |
q | Renewing: with cylinder head installed → Chapter, with cylinder head removed → Chapter |
11 - | Valve guide |
q | Checking → Chapter |
12 - | Roller rocker finger |
q | Inlet side |
q | With pressed-in hydraulic tappet |
q | Removing and installing → Chapter |
q | Do not interchange used roller rocker fingers (mark) |
q | Check roller bearing for play and ease of movement |
13 - | Roller rocker finger |
q | Exhaust side |
q | With pressed-in hydraulic tappet |
q | Removing and installing → Chapter |
q | Do not interchange used roller rocker fingers (mark) |
q | Check roller bearing for play and ease of movement |
14 - | Oil seals |
q | Renewing → Chapter |
15 - | Cylinder head |
16 - | Inlet valves |
q | Checking valves → Chapter |
q | Valve dimensions → Chapter |
17 - | Exhaust valves |
q | Checking valves → Chapter |
q | Valve dimensions → Chapter |
18 - | O-ring |
q | Renew |
19 - | Shaft |
q | For roller rocker fingers |
q | Removing and installing → Chapter „Removing and installing roller rocker fingers“ |
20 - | 10 Nm |
21 - | Screw plug, 10 Nm |
q | Apply locking fluid when installing; refer to → Electronic parts catalogue |
22 - | Shaft |
q | For roller rocker fingers |
q | Removing and installing → Chapter „Removing and installing roller rocker fingers“ |
23 - | Bearing shell |
q | Do not interchange used bearing shells (mark positions) |
q | Make sure that the retaining lugs are correctly seated in the bearing caps and the cylinder head |
24 - | Exhaust camshaft |
q | Checking axial clearance → Chapter |
q | Removing and installing → Chapter |
25 - | Inlet camshaft |
q | Checking axial clearance → Chapter |
q | Removing and installing → Chapter |
26 - | Bearing frame |
q | Note sequence for loosening and tightening → Chapter „Removing and installing camshafts“ |