Checking radial clearance of conrod bearings |
Special tools and workshop equipment required |
Note t
| Do not interchange used bearings. |
t
| Bearing shells worn down to nickel layer must be renewed |
–
| Remove conrod bearing caps. |
–
| Clean bearing caps and bearing journals. |
–
| Place Plastigage onto bearing journal or into bearing shells (length of Plastigage should correspond to width of bearing). |
–
| Fit conrod bearing cap and tighten to 30 Nm. Do not rotate crankshaft. |
–
| Remove conrod bearing caps once more. |
–
| Compare width of Plastigage with measurement scale: |
l
| Radial clearance (new): 0.015 ... 0.062 mm |
|
|
|