Audi A4 Mk2 Diesel Engine Crankshaft and Piston Components
| Sealing flanges and flywheel/drive plate - exploded view of components |
Note| Servicing clutch → Rep. Gr.30 |
| 1 - | 10 Nm |
| 2 - | 30 Nm |
| 3 - | Crankshaft oil seal |
| q | Removing and installing → Chapter |
| 4 - | O-ring for oil drilling |
| q | Renew |
| 5 - | Timing chain tensioner |
| q | Tighten to 35 Nm |
| 6 - | 10 Nm |
| 7 - | Guide tube for oil dipstick |
| 8 - | O-ring |
| q | Renew |
| 9 - | Sump (top section) |
| q | Removing and installing → Chapter |
| 10 - | 45 Nm |
| 11 - | Balance shaft housing |
| q | With balance shaft |
| q | Removing and installing → Chapter „Removing and installing sump (top section)“ |
| 12 - | 22 Nm |
| 13 - | Bolts |
| q | M6 to cylinder block = 13 Nm |
| q | M6 to sealing flange = 10 Nm |
| q | M7 = 16 Nm |
| q | For correct version refer to → Parts catalogue |
| 14 - | 45 Nm |
| 15 - | Bolts |
| q | M6 to cylinder block = 13 Nm |
| q | M6 to sealing flange = 10 Nm |
| q | M7 = 16 Nm |
| 16 - | Flywheel |
| q | Removing and installing dual-mass flywheel on vehicles with manual gearbox → Chapter |
| q | Removing and installing flywheel on vehicles with multitronic gearbox → Chapter |
| q | Removing and installing drive plate on vehicles with automatic gearbox 01V → Chapter |
| 17 - | Securing bolt |
| q | Renew |
| q | Tightening torque for dual-mass flywheel → Anchor |
| q | Tightening torque for flywheel → Anchor |
| q | Tightening torque for drive plate → Anchor |
| 18 - | Needle bearing |
| q | Extracting and driving in → Chapter |
| 19 - | Dowel pin |
| q | Only with manual gearbox |
| q | Check that pin is firmly seated in crankshaft |
| 20 - | 10 Nm |
| 21 - | Sealing flange (rear) with oil seal |
| q | Remove upper section of sump in order to remove and install → Chapter |
| q | Lubricate sealing lip of oil seal lightly |
| q | To install, push guide sleeve from installation kit onto crankshaft. |
| 22 - | Gasket |
| q | Renew |
| 23 - | Cylinder block |
| 24 - | Gasket |
| q | Renew |
| 25 - | Sealing flange (front) |
| q | Removing and installing → Chapter |
