A4 Mk2
Poly V-belt drive for power steering pump, alternator and viscous fan - exploded view of components |
1 - | Poly V-belt |
q | Before removing, mark direction of rotation with chalk or felt-tipped pen. If the belt runs in the opposite direction when it is refitted, this can cause breakage |
q | Removing and installing → Chapter |
q | Check for wear |
q | When installing, make sure it is properly seated on pulleys. |
2 - | Spacer sleeve |
q | Depending on version |
3 - | 22 Nm |
4 - | Alternator |
q | Removing and installing → Electrical system; Rep. Gr.27 |
5 - | 45 Nm |
6 - | 22 Nm |
7 - | Bracket |
q | For alternator |
8 - | 10 Nm |
9 - | 22 Nm |
10 - | Cover |
q | For idler roller |
11 - | 22 Nm |
12 - | Idler roller |
q | For poly V-belt |
13 - | Idler roller |
q | For poly V-belt |
14 - | Cover cap |
q | For access to toothed belt tensioning roller |
15 - | 45 Nm |
16 - | 10 Nm |
17 - | Bracket |
q | For viscous fan |
q | Removing and installing → Anchor |
q | Viscous fan bearings cannot be renewed separately → Chapter „Removing and installing viscous fan“ |
18 - | 22 Nm |
19 - | Pulley |
q | For viscous fan |
q | Removing and installing → Chapter |
20 - | Gasket |
q | Renew |
21 - | Bracket for power steering pump and oil cooler |
q | Removing and installing → Chapter |
22 - | 22 Nm |
23 - | Power steering pump |
q | Removing and installing → Running gear, front-wheel drive and four-wheel drive; Rep. Gr.48 |
q | Note installation position → Fig. |
24 - | 22 Nm |
25 - | Pulley |
q | For power steering pump |
q | Removing and installing → Fig. |
26 - | 22 Nm |
27 - | Vibration damper |
q | With pulley for poly V-belt |
q | Removing and installing → Chapter |
28 - | 22 Nm |
|