A4 Mk2
| Balance shaft - exploded view of components |
| 1 - | Balance shaft |
| q | Removing and installing → Chapter |
| 2 - | 60 Nm |
| q | Use Ø 8 mm drill bit as counterhold when loosening and tightening |
| 3 - | Balance weight (timing chain end) |
| q | Can only be fitted on balance shaft in one position. |
| 4 - | Bearing plate |
| 5 - | 13 Nm |
| 6 - | Balance weight (pulley end) |
| q | Can only be fitted on balance shaft in one position. |
| 7 - | 60 Nm |
| q | Use Ø 8 mm drill bit as counterhold when loosening and tightening |
