audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing flywheel - vehicles with multitronic gearbox > < Flywheel for vehicles with multitronic gearbox - exploded view

A4 Mk2

Removing and installing damper unit - vehicles with multitronic gearbox
Removing and installing damper unit - vehicles with multitronic gearbox
Special tools and workshop equipment required
   
t  Counterhold tool -10 - 201-
  W00-0254
Removing
Proceed as follows:
l  Gearbox removed.
–  Insert counterhold tool -10 - 201- to slacken bolts -arrow-.
  A13-0821
–  Remove bolts -1- and detach damper unit -A- from flywheel -B-.
Installing
Installation is carried out in the reverse order; note the following:
  Note
The part number of the damper unit is assigned to the gearbox code letters; for correct allocation refer to → Electronic parts catalogue.
–  Fit counterhold tool -10 - 201- the other way round to tighten bolts.
–  Align damper unit -A- on flywheel -B-.
l  The installation markings -2- must align.
–  Screw in bolts by hand until they make contact and tighten in diagonal sequence.
Tightening torque
  A37-0421
ComponentNm
Damper unit to flywheel22

   

Removing and installing flywheel - vehicles with multitronic gearbox > < Flywheel for vehicles with multitronic gearbox - exploded view