A4 Mk2
| Timing chain covers - exploded view |
| 1 - | Crankshaft oil seal (gearbox end) |
| q | Removing and installing → Chapter |
| 2 - | Dowel sleeve |
| q | 2x |
| 3 - | Bolt |
| q | Renew |
| q | Note correct sequence when tightening → Anchor |
| 4 - | O-ring |
| q | Renew |
| 5 - | Cover plate |
| 6 - | 9 Nm |
| 7 - | Heat shield |
| 8 - | 9 Nm |
| 9 - | Bolt |
| q | Renew |
| q | Note correct sequence when tightening → Anchor |
| 10 - | Timing chain cover (left-side) |
| q | Removing and installing → Chapter |
| 11 - | Gasket |
| q | Renew |
| 12 - | Bolt |
| q | Renew |
| q | Note correct sequence when tightening → Anchor |
| 13 - | Timing chain cover (right-side) |
| q | Removing and installing → Chapter |
| 14 - | Gasket |
| q | Renew |
| 15 - | Bolt |
| q | Renew |
| q | Note correct sequence when tightening → Anchor |
| 16 - | Dowel sleeve |
| q | 2x |
| 17 - | Sealing element |
| q | 2x |
| 18 - | Timing chain cover (bottom) |
| q | Removing and installing → Chapter |
| 19 - | M6: 9 Nm; M8: 23 Nm |
| q | Note correct sequence when tightening → Anchor |
