Checking radial clearance of conrod bearings |
Special tools and workshop equipment required |
–
| Remove conrod bearing cap. Clean bearing cap and bearing journal. |
–
| Place a length of Plastigage corresponding to the width of the bearing on the bearing journal or bearing shell. |
–
| Fit conrod bearing cap and tighten to 30 Nm. Do not rotate crankshaft. |
–
| Remove conrod bearing cap once more. |
–
| Compare width of Plastigage with measurement scale: |
l
| New: 0.015 ... 0.062 mm. |
|
|
|