audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Exhaust gas recirculation system > < Removing and installing exhaust gas temperature sender 2 for bank 1G448

A4 Mk2

Removing and installing temperature sender before particulate filterG506
Removing and installing temperature sender before particulate filter -G506-
Removing
  Note
All cable ties which are released or cut open when removing must be fitted in the same position when installing.
   
Vehicles with front-wheel drive:
–  Unplug electrical connector -2- and detach connector from bracket.
–  Move wiring clear.
–  Unscrew temperature sender before particulate filter -G506--item 1-.
  A26-10643
Vehicles with four-wheel drive:
–  Unplug electrical connector -2- and detach connector from bracket.
–  Move wiring clear.
–  Unscrew temperature sender before particulate filter -G506--item 1-.
Installing
Installation is carried out in the reverse order; note the following:
  Note
Fit all cable ties in the original positions when installing.
–  Note correct installation position of exhaust gas temperature sender 2, bank 1 -G448-:
l  Align temperature sender connection centrally between propshaft and body.
Tightening torque
  A26-10293
ComponentNm
Temperature sender before particulate filter -G506- to particulate filter45 1)
l  1) Grease thread with high-temperature paste; refer to → Electronic parts catalogue for high-temperature paste

   

Exhaust gas recirculation system > < Removing and installing exhaust gas temperature sender 2 for bank 1G448