A4 Mk2
| Poly V-belt drive for alternator - exploded view |
| 1 - | 22 Nm |
| 2 - | 55 Nm |
| 3 - | Tensioner for poly V-belt |
| 4 - | Poly V-belt |
| q | Check for wear |
| q | Do not kink |
| q | Before removing, mark direction of rotation with chalk or felt-tip pen. If the belt runs in the opposite direction when it is refitted, this can cause breakage. |
| q | Removing and installing → Chapter |
| q | When installing, make sure it is properly seated on pulleys. |
| 5 - | Cap |
| 6 - | 22 Nm |
| 7 - | Alternator |
| q | Removing and installing → Rep. Gr.27 |
| 8 - | M8: 22 Nm; M10: 46 Nm |
| 9 - | Dowel sleeve |
| q | For bracket for alternator |
| q | 2x |
| 10 - | Bracket for alternator |
| 11 - | 9 Nm |
| 12 - | Mounting bracket |
| q | For idler roller |
| 13 - | Idler roller for poly V-belt |
| 14 - | 22 Nm |
| 15 - | Vibration damper |
| q | Removing and installing → Chapter |
| 16 - | Bolt |
| q | Renew |
| q | Tightening sequence → Anchor |
| 17 - | Dowel sleeve |
| q | 2x |
| 18 - | Bracket |
| q | For tensioner for poly V-belt |
| 19 - | 9 Nm |
| q | Different lengths |
