Audi Workshop Service and Repair Manuals

Removing and installing ignition coils Special tools and workshop equipment required

t  Hose clamps for hoses up to 25 mm Ø -3094-

t  Puller -T40039-

Removing Cylinder bank 2 (left-side): –  Remove cover -1- on left side of engine compartment.

–  Clamp off coolant hose -2- using hose clamp -3094- and detach from coolant expansion tank. –  Seal off connection with a suitable plug. –  Unbolt coolant expansion tank -arrow-. –  Unplug electrical wire for coolant shortage indicator switch -F66- at expansion tank (bottom) and move expansion tank to one side (coolant hose -1- remains attached).

–  Pull dipstick -1- out of guide tube. –  Remove bolts -2- and -3-. –  Unplug electrical connectors at ignition coils. –  Push wiring harness to one side.

Cylinder bank 1 (right-side): –  Remove bolts -arrows-. –  Remove air ducts -1- and -2-.

–  Remove bolts -1- and -2-. –  Unplug electrical connectors at ignition coils. –  Push wiring harness to one side.

Continuation for both sides: –  Pull ignition coils out with puller -T40039-. Installing Install in reverse order.