| Removing and installing injectors |
| –
| Remove engine cover panel. |
| –
| Remove intake manifold and fuel rail → Chapter. |
| –
| Pull off retaining clip and detach injector. |
Note | The fuel hoses must be detached before renewing the fuel rail. |
| Installation is carried out in the reverse order; note the following: |
| l
| Renew the O-rings at all opened connections. (When renewing the front O-ring, ensure that the plastic cap is never removed from the injector head. The O-ring must be pulled off over the plastic cap). |
| l
| Lubricate the O-rings with clean engine oil. |
| l
| Make sure injectors are installed in correct position. |
| l
| Make sure retaining clips are properly connected. |
| l
| Position fuel rail together with injectors (properly secured) against intake manifold and press into place evenly. |
|
|
|
