A4 Mk2
Intake manifold (top section) - exploded view of components |
1 - | Variable intake manifold position sender -G513- |
2 - | 2.5 Nm |
3 - | 2.5 Nm |
4 - | Actuator for intake manifold change-over |
q | Installation position of toothed segments for intake manifold change-over → Fig. |
q | Replacement part is supplied together with -item 24- |
5 - | Seal |
q | Renew if damaged |
q | When renewing lever out with screwdriver |
q | Press in by hand |
6 - | Ball stud, 2.5 Nm |
7 - | Intake manifold (top section) |
q | Removing and installing → Chapter |
8 - | Throttle valve module -J338- |
9 - | 5 Nm |
10 - | Bracket for wiring harness |
11 - | Seal |
q | Renew |
12 - | Intake manifold flap valve -N316- |
13 - | 2.5 Nm |
14 - | Intake air temperature sender -G42- / intake manifold pressure sender -G71- |
15 - | O-ring |
q | Renew |
16 - | 2.5 Nm |
17 - | Pressure control valve for crankcase breather system |
18 - | O-ring |
q | Renew |
19 - | 6 Nm |
20 - | Washer |
21 - | Sleeve |
22 - | Gaskets |
q | Renew |
23 - | Seal |
q | Renew if damaged |
q | When renewing lever out with screwdriver |
q | Press in by hand |
24 - | Lever with toothed segment |
q | For intake manifold change-over |
q | Installation position of toothed segments → Fig. |
q | Replacement part is supplied together with -item 4- |
25 - | Seal |
q | Renew if damaged |
q | When renewing lever out with screwdriver |
q | Press in by hand |
26 - | Variable intake manifold flap change-over valve -N239- |
|