–
| Open hose clip -3- and disconnect air intake hose from air mass meter -G70-. |
–
| Unscrew both bolts from air mass meter -G70-. |
–
| Then carefully pull air mass meter -G70- out of guide on air cleaner housing. |
To ensure the proper function of the air mass meter -G70- it is important to observe the following notes and instructions. |
Note t
| If the air filter element is very dirty or wet, dirt or water could reach the air mass meter -G70- and affect the air mass value. This would lead to loss of power, since a smaller injection quantity is calculated. |
t
| Always use genuine part for air filter element. |
t
| Always renew seal of air mass meter -G70- if damaged (air leaks in intake system). |
t
| Use a silicone-free lubricant when installing the intake hose and seal. |
t
| Secure all hose connections with the correct type of hose clips (same as original equipment): → Parts catalogue |
–
| Check for salt residue, dirt and leaves in air mass meter and air intake hose (engine intake side). |
–
| Check for dirt in air duct leading to air filter element. If necessary, clean salt residue, dirt and leaves out of air cleaner housing (top and bottom sections); wash out or use a vacuum cleaner as required. Removing and installing air cleaner → Chapter. |
–
| Align seal in slot on air cleaner housing and carefully push air mass meter -G70- into air cleaner housing. |
The remaining installation steps are carried out in the reverse sequence. |
|
|
|