When working on the fuel supply/injection system, pay careful attention to the following “6 rules”: |
t
| Thoroughly clean all unions and surrounding areas before disconnecting. |
t
| Place parts that have been removed on a clean surface and cover them over. Use only lint-free cloths. |
t
| Carefully cover or seal open components if repairs cannot be carried out immediately. |
t
| Only install clean components; replacement parts should only be unpacked immediately prior to installation. Do not use parts that have been stored loose (e.g. in tool boxes etc.). |
t
| When the system is open: Do not work with compressed air if this can be avoided. Do not move the vehicle unless absolutely necessary. |
t
| Also ensure that no diesel fuel comes into contact with the coolant hoses. Should this occur, the hoses must be cleaned immediately. Damaged hoses must be renewed. |
|
|
|