| –
| Pull out release pin -arrow- and pull bottom section of air cleaner housing upwards out of rubber grommets. |
| To ensure the proper function of the air mass meter -G70- it is important to observe the following notes and instructions. |
Note | t
| If the air filter element is very dirty or wet, dirt or water could reach the air mass meter -G70- and affect the air mass value. This would lead to loss of power, since a smaller injection quantity is calculated. |
| t
| Always use genuine part for air filter element. |
| t
| Use a silicone-free lubricant when installing the intake hose. |
| t
| Secure all hose connections with the correct type of hose clips (same as original equipment) → Parts catalogue |
| –
| Check water drain hose in air cleaner housing (bottom section) for dirt and leaves (use a vacuum cleaner if necessary). |
| –
| Clean salt residue, dirt and leaves out of air cleaner housing (top and bottom sections); use a vacuum cleaner if necessary. |
| –
| Check for salt residue, dirt and leaves in air mass meter and air intake hose (engine intake side). |
| –
| Check for dirt in air duct leading to air filter element. |
| –
| When installing the air filter element, check that it is properly centred in the retainer in the air cleaner (bottom section). |
| –
| Fit the top section of the air cleaner housing carefully on the bottom section, without using force. Make sure the top section of the air cleaner housing is fitted straight on the air filter element. Note position of sealing lip on air filter element (to prevent air leaks). |
| –
| Then secure top section of air cleaner housing to bottom section. |
| –
| The remaining installation steps are carried out in the reverse sequence. |
|
|
|
