A4 Mk2
| Toothed belt for high-pressure pump - exploded view |
| 1 - | Toothed belt cover (front) |
| q | Engage in position at the bottom at clip on at the side |
| 2 - | Nut |
| q | 70 Nm |
| q | Use counterhold tool -3036- when loosening and tightening → Fig. |
| 3 - | Damper weight |
| q | Use counterhold tool -3036- when loosening and tightening central nut → Fig. |
| 4 - | Bolt |
| q | 23 Nm |
| 5 - | Toothed belt sprocket for high-pressure pump |
| q | Remove using puller -T40064- → Fig. |
| 6 - | Toothed belt tensioning roller |
| 7 - | Bolt |
| q | 9 Nm |
| 8 - | Toothed belt cover (rear) |
| 9 - | Toothed belt drive sprocket |
| q | Use counterhold tool -3036- when loosening and tightening central bolt → Fig. |
| q | Pulling off: vehicles up to 02.2006 → Fig.; vehicles from 02.2006 onwards → Fig. |
| 10 - | Bolt |
| q | 75 Nm |
| q | With washer |
| q | Use counterhold tool -3036- when loosening and tightening → Fig. |
| 11 - | Toothed belt for high-pressure pump |
| q | Before removing, mark direction of rotation with chalk or felt-tip pen. If the belt runs in the opposite direction when it is refitted, this can cause breakage. |
| q | Check for wear |
| q | Removing and installing: vehicles up to 02.2006 → Chapter; vehicles from 02.2006 onwards → Chapter |
|
|
|
|
|
|
|
|
|
|
