Audi Workshop Service and Repair Manuals

Removing and installing anti-roll bar Special tools and workshop equipment required

t  Torque wrench -V.A.G 1331-

Removing –  Remove noise insulation. –  Remove bolt -2-.

–  Unscrew hexagon nuts -2-. –  Take out anti-roll bar. Installing   Note t  If renewing the anti-roll bar, check the suspension version fitted on the vehicle. t  Anti-roll bar and bushes must be free of grease.

–  Fit new nuts -2-, but do not tighten yet.

–  Tighten new bolt -2- → Item.

–  Tighten nuts -2- to 25 Nm. –  Install noise insulation → Rep. Gr.50..