Audi Workshop Service and Repair Manuals > A4 Mk2 > Running gear, front-wheel drive and four-wheel drive | Rear suspension, drive shaft | Lightweight wheel hub

Removing and installing deflector ring

Special tools and workshop equipment required

t	Assembly tool -T40089/1-

t	Press tool -VW 473-

t	Thrust plate -VW 401-

Renewing deflector ring

–	Carefully pry off deflector ring -1- using a screwdriver or similar.

–	Position deflector ring on wheel hub.

–	Apply special tools as shown in illustration.

1 -	Press tool -VW 473-

2 -	Assembly tool -T40089/1-

3 -	Deflector ring

4 -

Wheel hub

5 -	Thrust plate -VW 401-

–	Press on deflector ring as far as radius on wheel hub using assembly tool -T40089/1- as illustrated.

Note

The deflector ring must be pressed on until it is seated against the radius on the wheel hub.

Audi Workshop Service and Repair Manuals