Audi Workshop Service and Repair Manuals > A4 Mk2 > Running gear, front-wheel drive and four-wheel drive | Rear suspension, drive shaft | Vehicle level sender for vehicles with automatic headlight range control

Renewing vehicle level sender in vehicle

Special tools and workshop equipment required

t	Torque wrench -V.A.G 1331-

–	Remove wheel.

–	Remove bolt -1-.

–	Unscrew bolts -2- with angled spanner. Take care not to bend upper retaining plate.

For ease of illustration, transverse link is not shown.

–	Prepare replacement part accordingly and install.

Note

Hold vehicle level sender while tightening bolts -2-.

Tightening torques:

-	Item 1: 10 Nm

-	Item 2: 5 Nm

–	Perform basic setting of headlights following replacement. → Electrical system; Rep. Gr. 94; Servicing headlights; Adjusting headlights

–	Fit and secure wheel → Wheels and tyres; Rep. Gr.44.

Audi Workshop Service and Repair Manuals