Checking steering system for leaks |
Note The steering system must be checked for leaks after repair work and if the hydraulic fluid level in the reservoir is low. |
–
| Turn steering to full lock on both sides and hold briefly. This builds up the maximum possible pressure. |
To avoid damaging the pump, the steering wheel must not be held on full lock for more than 10 seconds during this test. |
Check the following components for leaks with the steering in this position: |
t
| Pinion seal on steering box valve housing |
This check can only be carried out when the rubber boots are pushed back. |
–
| Open hose clips (spring-type clip and clip with lug fastener) on rubber boot. |
The steering box must be renewed if fluid is visible in the steering box housing and/or in the rubber boots. |
|
|
|