–
| Release headlight range control motor: at right-side headlight by turning anti-clockwise -arrow-; at left-side headlight by turning clockwise. |
–
| Press ball head of actuator shaft downwards out of its mounting by tilting control motor. |
–
| Unplug electrical connector. |
Installation is carried out in the reverse order; note the following: |
–
| Start by inserting ball head of actuator shaft in mounting on reflector from below; to do so, pull reflector to rear. |
–
| Secure housing cover with retaining clip. |
Note The headlights must always be adjusted if the control motors are removed and installed or renewed → Booklet803. |
|
|
|