Audi Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Rear light (Avant) - exploded view >
< Rear light (Saloon) - exploded view
A4 Mk2
Vehicle electrics
Electrical system
Lights, lamps, switches outside
Rear lights - vehicles up to 10.2004
Removing and installing rear light and bulb carrier (Saloon)
Removing and installing rear light and bulb carrier (Saloon)
Removing and installing rear light and bulb carrier (Saloon)
Removing
–
Switch off ignition and take out ignition key.
–
Turn light switch to position “0”.
–
Fold pre-punched area
-1-
of luggage compartment lining forwards.
–
Remove bolt
-3-
.
–
Swivel rear light outwards, and at the same time disengage retaining pins from body.
–
Unplug electrical connector at bulb carrier.
–
Press retaining clips together
-arrows-
and take bulb carrier out of rear light.
–
Turn bulbs to remove them from their holders.
Installing
Installation is carried out in the reverse order; note the following:
Note
Ensure that seal between body and rear light housing seals completely.
–
Fit rear light in position on body and press retaining pins into holes.
–
Tighten bolt
-3-
.
Note
After unfastening nut
-2-
, rear light can be aligned with body contours (uniform gap widths).
Tightening torques
Component
Nm
Nut for rear light to body
12
Rear light to body
6
Vehicle electrics
Electrical system
Lights, lamps, switches outside
Rear lights - vehicles up to 10.2004
Removing and installing rear light and bulb carrier (Saloon)
Rear light (Avant) - exploded view >
< Rear light (Saloon) - exploded view