audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing exterior door handle > < Exploded view - exterior door handle and door lock

A4 Mk3

Removing and installing housing
   
Removing and installing housing
1 - Cap
q   Detaching from housing → Anchor
2 - Magnet
q   Only for vehicles with Keyless Entry system
3 - Housing
q   Unscrew bolt all the way out of retaining clip with a screwdriver.
–  Press back retainer with screwdriver and pull housing with cap out towards side.

   
Removing
–  Push outer door seal to side and peel off protective film over hole -arrow A-.
–  Unscrew clamping bolt -4- as far as possible using a screwdriver -1-.
–  Push retaining clip -3- for housing inwards.
–  Pull housing -2- out of mounting bracket -arrow B-.
Installing
Install in reverse order of removal.
  A58-10108
Removing housing cap
–  Remove housing → Chapter.
–  Pull retaining clips apart -arrows- and detach cap -1- from housing -2-, using an awl if necessary.
Installing
Installation is carried out in the reverse order; note the following:
–  Press on housing cap until it engages audibly.
  A58-10109

Removing and installing exterior door handle > < Exploded view - exterior door handle and door lock