A4 Mk3
| Removing and installing window regulator motor |
| 1 - | Electrical connector |
| – | Unplug electrical connector at door control unit. |
| 2 - | Window regulator motor |
Note| The window regulator motor can be removed or installed with the motor or door window in any position. |
| q | Removing: |
| – | Remove door trim → Rep. gr.70. |
| – | Unscrew bolts -6- and detach window regulator motor from window regulator. |
| q | Installing |
| l | Tightening torque → Chapter |
| Installation is carried out in the reverse order; note the following: |
| l | Retaining clips -arrow- of threaded pins for window regulator must be engaged in inner door panel. |
| – | Slide window regulator motor onto threaded pins and tighten bolts -6-. |
Note| t | With the window regulator switches connected, switch on the ignition and raise the door windows as far as they will go. |
| t | Keep the window regulator switches pulled for approx. another 2 seconds to activate the basic setting and the one-touch open/close function. |
| 3 - | Threaded pin |
| 4 - | Window regulator |
| 5 - | Bolt |
