Connecting air conditioner service station on vehicles with no connection on the low-pressure end of the refrigerant circuit |
On the following vehicles, no service connection is provided for the air conditioner service station on the low-pressure end of the refrigerant circuit. Adapters are required for connecting the air conditioner service station to the refrigerant circuit of these vehicles. |
t
| Audi 80, Audi Cabriolet, Audi Coupé |
t
| Audi 100 / Audi A6 up to 03.97 |
Note On vehicles with no or an inaccessible connection at the air conditioner compressor, remove the low-pressure switch for air conditioning system -F73- (jumper the contacts in the connector for the low-pressure switch for air conditioning system -F73-) and screw an adapter to this connection → Heating, air conditioning; Rep. gr.87 or → Air conditioning; Rep. gr.87 (vehicle-specific workshop manual). |
Note t
| The tools listed below are commercially available or can be obtained from the regional sales centre or importer. |
t
| Should it be necessary to measure pressures at switch connections on high-pressure side, use adapter from adapter set for refrigerant circuit -V.A.G 1785/9- and proceed in the same manner. |
t
| Connecting air conditioner service station to refrigerant circuit with adapter set for refrigerant circuit -V.A.G 1786- → Chapter |
t
| Connecting air conditioner service station to refrigerant circuit with adapter V.A.G 1785/10 → Chapter |
t
| Connecting air conditioner service station for measuring and testing → Chapter |
|
|
|