A4 Mk3
Note
|
| 1 - | Oil seal for flange shaft (left-side) |
| q | Between final drive and gearbox housing |
| q | → Chapter „Renewing oil seal for flange shaft (left-side)“ |
| 2 - | Shim |
| q | Behind tapered roller bearing outer race |
| 3 - | Tapered roller bearing outer race |
| 4 - | Bolt |
| q | 11x |
| q | Tightening torque and sequence → Fig. |
| 5 - | Oil seal for flange shaft (right-side) |
| q | → Chapter „Renewing oil seal for flange shaft (right-side)“ |
| 6 - | Flange shaft (right-side) |
| q | → Chapter „Removing and installing flange shaft (right-side)“ |
| 7 - | Circlip |
| q | Renew |
| 8 - | Screw plug |
| q | For oil filler hole |
| q | Renew |
| q | 35 Nm |
| 9 - | Cover for front final drive |
| q | Pay attention to dowel sleeves |
| 10 - | Shim |
| q | Behind tapered roller bearing outer race |
| 11 - | Tapered roller bearing outer race |
| 12 - | O-ring |
| q | On cover for front final drive |
| q | → Chapter „Renewing O-ring on cover for front final drive“ |
| 13 - | Differential |
| 14 - | Gearbox |
| 15 - | Spring pin |
| 16 - | Selector shaft lever |
| 17 - | Oil seal for selector shaft |
| q | → Chapter „Renewing oil seal for selector shaft“ |
| 18 - | Flange shaft (left-side) |
| q | → Chapter „Removing and installing flange shaft (left-side)“ |
| 19 - | Bolt |
| q | 10 Nm + 45° |
| 20 - | Bearing plate |
| q | Secured to flange shaft together with bearing → Item via retaining clip → Item |
| q | Together they are referred to as mounting bracket for flange shaft (left-side) |
| 21 - | Bearing |
| q | For flange shaft (left-side) |
| 22 - | Retaining clip |
| q | For bearing on flange shaft (left-side) |
| 23 - | Oil seal for torque converter |
| q | → Chapter „Renewing oil seal for torque converter“ |
| 24 - | Torque converter |
| q | → Chapter „Removing and installing torque converter“ |
|
|