audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing end cover > < Removing and installing ATF filter

A4 Mk3

Exploded view - end cover, automatic gearbox control unitJ217, hydraulic control unit
Exploded view - end cover, automatic gearbox control unit -J217-, hydraulic control unit
  Caution
Risk of damage to gearbox
Do not run engine or tow vehicle with end cover removed or when there is no ATF in the gearbox.
  Note
t  Observe the general repair instructions → Chapter.
t  Rules for cleanliness when working on the automatic gearbox → Chapter.
   
1 - Gearbox
2 - Axial sealing element, small
q   Renew
3 - Axial sealing element, large
q   Renew
4 - Roller
5 - Lever for selector shaft detent
6 - Spring
7 - Seal
q   For connector on automatic gearbox control unit -J217-
8 - Bolt
q   Tightening torque → Servicing multitronic 0AW, front-wheel drive; Rep. gr.38
9 - End cover
q   → Chapter „Removing and installing end cover“
10 - Gasket
q   Renew
11 - Bolt
q   Tightening torque → Servicing multitronic 0AW; Rep. gr.38
12 - Automatic gearbox control unit -J217-
q   → Chapter „Removing and installing automatic gearbox control unit -J217-“
13 - Bolt
q   Tightening torque → Servicing multitronic 0AW; Rep. gr.38
14 - Hydraulic control unit
q   → Chapter „Removing and installing hydraulic control unit“

   

Removing and installing end cover > < Removing and installing ATF filter