audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Renewing input shaft oil seal - Audi A4 2008 ?; Audi A5 Coupé 2008 ? from gearbox serial number 000761 onwards > < Renewing input shaft oil seal

A4 Mk3

Renewing input shaft oil seal - Audi A5 Coupé 2008 ▸ up to gearbox serial number 000760
Renewing input shaft oil seal - Audi A5 Coupé 2008 ► up to gearbox serial number 000760
  Note
Gearboxes with these serial numbers were installed only in the Audi A5 Coupé 2008 ►.
Special tools and workshop equipment required
   
t  Extractor tool -T20143/1-
  W00-2958
t  Fitting tool -T10122-
  W00-1234
t  Thrust piece -T10184-
t  Sealing grease -G 052 128 A1-
l  Gearbox removed → 6-speed manual gearbox 0B4, four-wheel drive; Rep. Gr.34
–  Remove clutch module → Chapter.
  W00-1350
–  Prise out input shaft oil seal.
  A39-10265
–  Lightly oil outer circumference of new oil seal.
–  Pack space between sealing lip and dust lip half-full with sealing grease -G 052 128 A1-.
–  Drive in new oil seal until flush (take care to keep seal straight).
–  Install clutch module → Anchor.
  A39-10266

Renewing input shaft oil seal - Audi A4 2008 ?; Audi A5 Coupé 2008 ? from gearbox serial number 000761 onwards > < Renewing input shaft oil seal