A4 Mk3
| Exploded view - front final drive and oil seals |
| 1 - | Flywheel |
| q | Removing and installing → Chapter |
| 2 - | Oil seal |
| q | For flange shaft (left-side) |
| q | Between final drive and gearbox housing |
| q | Renewing → Chapter |
| 3 - | Shim |
| q | Behind tapered roller bearing outer race |
| 4 - | Tapered roller bearing outer race |
| 5 - | Differential |
| 6 - | Bolt |
| q | 10x |
| q | Tightening torque and sequence → Fig. |
| 7 - | Circlip |
| q | Renew |
| 8 - | Flange shaft (right-side) |
| q | Removing and installing → Chapter |
| 9 - | Oil seal |
| q | For flange shaft (right-side) |
| q | Renewing → Chapter |
| 10 - | Cover for front final drive |
| q | Removing and installing → Chapter |
| 11 - | O-ring |
| q | On cover for front final drive |
| q | Renew |
| 12 - | Shim |
| q | Behind tapered roller bearing outer race |
| 13 - | Tapered roller bearing outer race |
| 14 - | Spring pin |
| 15 - | Gearbox selector lever |
| 16 - | Oil seal |
| q | For selector shaft |
| q | Renewing → 7-speed dual clutch gearbox 0B5 (S tronic); Rep. gr.34 |
| 17 - | Bolt |
| q | 3x |
| q | 10 Nm + 45° |
| 18 - | Flange shaft (left-side) |
| q | Removing and installing → Chapter |
| 19 - | Mounting bracket |
| q | Secured to flange shaft (left-side) together with bearing -item 20- by circlip -21-. |
| q | If wear is visible on mounting bracket, check preload of ball bearing for flange shaft (left-side) → Chapter |
| 20 - | Bearing |
| q | For flange shaft (left-side) |
| q | Checking preload of ball bearing for flange shaft (left-side) → Chapter |
| q | Renewing → Chapter |
| 21 - | Circlip |
| q | For bearing for flange shaft (left-side) |
| q | Renew |
| 22 - | Oil seal |
| q | For input shaft |
| q | Renewing → Chapter |
Note
|
|
| Stage | Bolts | Tightening torque/tightening angle |
| 1. | -1 … 10- | 3 Nm |
| 2. | -1 … 10- | 20 Nm |
| 3. | -1 … 10- | Turn 90° further |
