| Measuring radial clearance of conrods |
| Special tools and workshop equipment required |
| –
| Remove conrod bearing cap. |
| –
| Clean bearing cap and bearing journal. |
| –
| Place a length of Plastigage corresponding to the width of the bearing on the bearing journal or in the bearing shell. |
| –
| Fit conrod bearing caps and tighten to 30 Nm without turning bolts further; do not rotate crankshaft. |
| –
| Remove conrod bearing cap again. |
| –
| Compare width of Plastigage with measurement scale. |
|
|
|
