A4 Mk3
| Turbocharger - exploded view |
| 1 - | Air hose |
| 2 - | Pulsation damper |
| 3 - | Oil return line |
| 4 - | Bolt |
| q | 9 Nm |
| 5 - | Gasket |
| q | Renew |
| 6 - | Threaded connection |
| q | 40 Nm |
| 7 - | Gasket |
| q | Renew |
| 8 - | Bolt |
| q | 20 Nm |
| 9 - | Turbocharger |
| q | Can only be renewed together with vacuum unit |
| q | Removing and installing → Chapter |
| 10 - | Gasket |
| q | Renew |
| 11 - | Nut |
| q | Renew |
| q | Coat thread with high-temperature paste; for high-temperature paste refer to → Electronic parts catalogue |
| q | 24 Nm |
| 12 - | Particulate filter |
| q | Removing and installing → Chapter |
| 13 - | Exhaust gas temperature sender 1 -G235- |
| q | Exploded view → Chapter |
| 14 - | Banjo bolt |
| q | 30 Nm |
| 15 - | Oil supply line |
| q | Check for obstructions |
| q | Before installing, fill turbocharger with engine oil at connection for oil supply line |
| q | Tighten union nuts to 22 Nm. |
| 16 - | Bolt |
| q | 9 Nm |
| 17 - | Seals |
| q | Renew |
| 18 - | Exhaust manifold |
| q | Removing and installing → Chapter |
| 19 - | Nut |
| q | Renew |
| q | Coat thread with high-temperature paste; for high-temperature paste refer to → Electronic parts catalogue |
| q | 24 Nm |
| 20 - | Vacuum hose |
| 21 - | Hose |
| q | For crankcase breather |
| q | Optional equipment for countries with cold climates: with heater element for crankcase breather -N79- |
| 22 - | Air pipe |
| 23 - | Support |
| q | For turbocharger |
| 24 - | Bolt |
| q | 40 Nm |
| 25 - | Bolt |
| q | 9 Nm |
