Audi Workshop Service and Repair Manuals > A4 Mk3 > Power unit | 6-cylinder direct petrol injection engine (3.2 ltr. 4-valve), mechanics | Engine lubrication | Oil pump and sump (bottom section) | Removing and installing oil level and oil temperature sender G266

Removing and installing oil level and oil temperature senderG266

Removing and installing oil level and oil temperature sender -G266-

Removing

–	Drain engine oil → Booklet811, → Booklet812 or → Booklet818.

–	Unplug electrical connector -3-.

–	Remove nuts -1- and detach oil level and oil temperature sender -G266--item 4-.

Installing

l	Tightening torque → Chapter.

Installation is carried out in the reverse order; note the following:

Note

Renew seal -2-.

–	Fill up with engine oil and check engine oil level → Booklet811, → Booklet812 or → Booklet818.

Audi Workshop Service and Repair Manuals