audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Removing and installing poly V-belt - vehicles with hydraulic power steering > < Removing and installing poly V-belt tensioner for supercharger
Poly V-belt drive for vehicles with hydraulic power steering - exploded view
   
Poly V-belt drive for vehicles with hydraulic power steering - exploded view
1 - Poly V-belt
q   Check for wear
q   Before removing, mark direction of rotation with chalk or felt-tip pen
q   Removing and installing → Chapter
q   Do not kink
q   When installing, make sure it is properly seated on pulleys
2 - Bolt
q   Renew
q   20 Nm + turn 90° further
3 - Alternator
q   Removing and installing → Electrical system; Rep. gr.27
4 - Bolt
q   Tightening torque → Electrical system; Rep. gr.27
5 - Cover for idler roller
6 - Idler roller for poly V-belt
q   40 Nm
7 - Bolt
q   Tightening torque and sequence → Fig.
8 - Bolt
q   Tightening torque → Item
9 - Poly V-belt pulley for coolant pump
q   Removing and installing → Chapter „Removing and installing coolant pump“
10 - Bolt
q   Tightening torque → Item
11 - Coolant pump
q   Removing and installing → Chapter
12 - Sealing flange (pulley end)
q   Renewing → Chapter
13 - Bolt
q   Tightening torque → Rep. gr.48
14 - Bracket for power steering pump
15 - Sliding bush
16 - Bolt
q   Tightening torque → Rep. gr.48
17 - Power steering pump
q   Removing and installing → Rep. gr.48
18 - Pulley for power steering pump
q   Removing and installing → Rep. gr.48
19 - Bolt
q   Tightening torque → Rep. gr.48
20 - Poly V-belt tensioner
q   Removing and installing → Chapter
q   40 Nm
21 - Bracket for air conditioner compressor
q   Removing and installing → Rep. gr.87
22 - Bolt
q   Tightening torque → Rep. gr.87
23 - Air conditioner compressor
q   Do not unscrew or disconnect refrigerant hoses or pipes.
q   Removing and installing → Rep. gr.87
24 - Bolt
q   Tightening torque → Rep. gr.87
25 - Dowel sleeve
q   2x
26 - Cover for tensioner
27 - Vibration damper
q   With double-sided poly V-belt pulley
q   Removing and installing → Chapter

   
Sealing flange (pulley end) - tightening torque and sequence
–  Tighten bolts -arrows- in stages and in diagonal sequence; final torque 9 Nm.
  A13-10009

Removing and installing poly V-belt - vehicles with hydraulic power steering > < Removing and installing poly V-belt tensioner for supercharger