Audi Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing coolant pipe (front left) >
< Removing and installing coolant pipe (front)
A4 Mk3
Power unit
6-cylinder TDI engine (3.0 ltr. 4-valve common rail - generation II), mechanics
Engine cooling
Coolant pipes, coolant shut-off valve, coolant temperature sender
Removing and installing coolant pipe (rear left)
Removing and installing coolant pipe (rear left)
Removing and installing coolant pipe (rear left)
Special tools and workshop equipment required
t
Hose clip pliers -VAS 6362-
Removing
–
Drain coolant
→ Chapter
.
–
Remove engine mounting (left-side)
→ Chapter
.
–
Unscrew bolts
-arrows-
and remove engine support (left-side).
–
Remove bolts
-1-
.
–
Release hose clips
-arrows-
and detach coolant hoses from coolant pipe.
–
Detach coolant pipe (rear left).
Installing
Installation is carried out in the reverse order; note the following:
l
Tightening torques
→ Chapter „Coolant pipes - exploded view“
Note
Secure all hose connections with the correct type of hose clips (same as original equipment)
→ Electronic parts catalogue
.
–
Install engine support and engine mounting
→ Chapter
.
–
Fill up with coolant
→ Anchor
.
Power unit
6-cylinder TDI engine (3.0 ltr. 4-valve common rail - generation II), mechanics
Engine cooling
Coolant pipes, coolant shut-off valve, coolant temperature sender
Removing and installing coolant pipe (rear left)
Removing and installing coolant pipe (front left) >
< Removing and installing coolant pipe (front)