audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing Hall senderG40 > < Removing and installing glow plugs

A4 Mk3

Removing and installing engine speed senderG28
Removing and installing engine speed sender -G28-
Special tools and workshop equipment required
   
t  Socket (4 mm) -T10370-
  W00-10582
t  Assembly tool -T10118-
Removing
  W00-1148
–  Remove oil filter bracket → Rep. gr.17.
–  Unplug electrical connector at engine speed sender -G28--arrow- using assembly tool -T10118-.
  Note
To release electrical connector without assembly tool -T10118-, press connector on engine speed sender in with a screwdriver and at the same time lift release tab with a thin wire hook.
–  Move wiring clear.
  A23-0205
–  Unscrew securing bolt -2- for engine speed sender -G28--item 1-.
Installing
Installation is carried out in the reverse order; note the following:
–  Install oil filter bracket → Rep. gr.17.
l  Tightening torque: refer to overview of fitting locations → Chapter.
  A23-0209

Removing and installing Hall senderG40 > < Removing and installing glow plugs