A4 Mk3
Note
|
1 - | Retaining clamp |
q | 5.5 Nm |
q | Reinforced |
2 - | Throttle valve module -J338- |
q | 9 Nm |
3 - | O-ring |
q | Renew |
4 - | Bolt |
q | 9 Nm |
q | Tighten in stages and in diagonal sequence |
5 - | Bolt |
q | 9 Nm |
6 - | Gasket |
q | Renew |
7 - | Connecting pipe for exhaust gas recirculation |
8 - | Intake manifold (top section) |
q | Removing and installing → Chapter |
9 - | Seal |
q | Renew |
10 - | Screw plug |
q | 10 Nm |
11 - | Bolt |
q | 9 Nm |
12 - | Mounting pin for engine cover panel |
q | 5 Nm |
13 - | Bolt |
q | 9 Nm |
14 - | Gasket |
q | Check for damage and renew if necessary |
15 - | Intake manifold flap motor |
q | Cylinder bank 1 (right-side): intake manifold flap motor -V157- |
q | Cylinder bank 2 (left-side): intake manifold flap motor -V275- |
16 - | Bolt |
q | 10 Nm |
17 - | Securing clip |
18 - | Connecting rod |
19 - | Coupling |
20 - | Bottom section of intake manifold |
21 - | Gasket |
q | Check for damage and renew if necessary |
22 - | Air hose |
q | Must be free of oil and grease when installing |