t
| Reference table for reading out letters and/or numbers on each injector |
Special tools and workshop equipment required |
The adaption procedure is described in the „Guided Fault Finding“. (The procedure is also described under „Guided Functions“.) Use → Vehicle diagnostic tester |
–
| When a new injector is installed, the adaption value for the new injector must be stored in the engine control unit. |
–
| Additionally, check that the „Injector delivery calibration values“ with „Injector voltage calibration values“ are correctly entered for all the other injectors. Do NOT attempt to re-enter these values if the correct values are already stored in the engine control unit. |
–
| When the engine control unit is renewed, the appropriate „Injector delivery calibration values“ with „Injector voltage calibration“ values must be written into the new engine control unit. |
|
|
|