audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Adjustment procedure using ACC setting deviceVAS 6190 > < Removing and installing sensor for adaptive cruise controlG550

A4 Mk3

Preparing ACC setting deviceVAS 6190 for adjustment procedure
Preparing ACC setting device -VAS 6190- for adjustment procedure
Special tools and workshop equipment required
   
t  ACC setting device -VAS 6190-
Before commencing the adjustment procedure, check which mountings the vertical slide on the ACC setting device -VAS 6190- is attached to. If necessary, the position of the attachments on the ACC setting device -VAS 6190- must be changed before performing the adjustment.
The attachments on the ACC setting device -VAS 6190- must be changed BEFORE performing the adjustment. If this is done during the adjustment procedure, the pre-adjustment of the ACC setting device -VAS 6190- will have to be repeated.
  W00-10094
–  Prior to the adjustment procedure, the vertical slide must be fitted in mountings -1- to -4- so that the laser beam (vertical alignment) coincides approximately with the centre of the sensor lens.
  A44-10086
–  The original nut at the top of the horizontal slide must be replaced with a nut -3- (normal commercially available type).
  Note
The original nut at the top of the horizontal slide has to be replaced with a nut of the normal commercially available type so that the mirror can be moved far enough towards the centre.
  A44-10088
–  The centrally mounted mirror -1- must be detached and re-fitted at the extreme left -arrow-, next to the vertical slide -2-.
  A44-10087
–  The mirror -1- on the horizontal slide must then be moved as far as at will go against the vertical slide -2-.
  A44-10088

Adjustment procedure using ACC setting deviceVAS 6190 > < Removing and installing sensor for adaptive cruise controlG550