audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Connector at data bus diagnostic interfaceJ533 > < Data bus diagnostic interfaceJ533

A4 Mk3

Removing and installing data bus diagnostic interfaceJ533
Removing and installing data bus diagnostic interface -J533-
Special tools and workshop equipment required
   
t  Protective cap for cable connector -VAS 6223/9- from fibre-optic conductor repair set -VAS 6223-
–  When renewing control unit select „Replacement“ function for appropriate control unit in „Guided Fault Finding“ or „Guided Functions“ → Vehicle diagnostic tester.
  W00-10202
Removing
–  Switch off ignition and take out ignition key.
–  Remove glove box → Rep. gr.68.
–  Remove bolt -2-.
–  Take data bus diagnostic interface -J533--item 3- out of retainer -arrow-.
–  Unplug electrical connector -4-.
–  Unplug connector for fibre optic cable -1-.
  A90-10076
–  Seal open connector plug -2- of fibre optic cable with protective cap for cable connector -VAS 6223/9--item 1-.
  Note
Protective cap prevents contamination of or mechanical damage to end face of fibre optic cable which would impair light transmission.
Installing
l  Tightening torque → Chapter
Installation is carried out in the reverse order; note the following:
–  Install glove box → Rep. gr.68.
–  Continue to follow the instructions on the display of the vehicle diagnostic tester for a new data bus diagnostic interface -J533-.
  A97-0760

Connector at data bus diagnostic interfaceJ533 > < Data bus diagnostic interfaceJ533