audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing rear fog light bulb L46/L47 > < Exploded view of inner tail light cluster

A4 Mk3

Removing and installing inner tail light cluster
Removing and installing inner tail light cluster
   
Removing
–  Switch off ignition and take out ignition key.
–  Turn light switch to position „0“.
–  Remove cover -1- towards outside of vehicle -arrow-.
  A94-10683
–  Unplug electrical connector -2-.
–  Remove nut -3- and remove retainer bracket -4-.
–  Swivel inner tail light slightly outwards -arrow A- and detach from rear lid in direction of -arrow B-.
Installing
Installation is carried out in the reverse order; note the following:
l  Tightening torque → Chapter
  Note
Ensure that seal between body and tail light housing seals completely.
  A94-10842
–  Position inner tail light cluster at outer edge of rear lid.
–  Slide retainer bracket -2- onto stud of inner tail light.
l  Guide pin -4- on tail light must engage in mounting -3- on retainer bracket.
–  Tighten nut -1-.
  Note
As the nut is tightened the retainer bracket becomes wedged in the rear lid -arrows-.
  A94-10844

Removing and installing rear fog light bulb L46/L47 > < Exploded view of inner tail light cluster