A4 Quattro Cabriolet L4-2.0L Turbo (BWT) (2009)
Specified value: battery voltage.
Switch the ignition off.
If the specified value was not obtained:
-
Check the wiring from the Fuel Metering Valve ( N290) electrical connector terminal 1 to the Engine Component Power Supply Relay (J757)
socket 2/87 for an open circuit, a short circuit to each other, Battery (+), and Ground (GND).
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the wiring connection.
If no malfunctions are found in the wiring:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box. Refer to Fuel Injection and Ignition Repair Information
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) (J623). Refer to => [ Engine Control Module, Replacing ] See: Computers and Control
Systems/Engine Control Module/Service and Repair.
-
Using a multimeter, check the Fuel Metering Valve (N290) electrical harness connector terminals to the Engine Control Module (ECM) (J623)
electrical harness connector T60 terminals for resistance.