A4 Quattro Cabriolet L4-2.0L Turbo (BWT) (2009)
-
Start engine and let it run at idle.
-
Using a multimeter, check the Charge Air Pressure Sensor (G31) electrical harness connector terminals 1 to 3 for voltage.
Specified value: min. 4.5 V
-
Switch the ignition off.
If the specification was not obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box. Refer to Fuel Injection and Ignition Repair Information
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) (J623). Refer to => [ Engine Control Module, Replacing ] See: Computers and Control
Systems/Engine Control Module/Service and Repair.
-
Using a multimeter, check the Charge Air Pressure Sensor (G31) electrical harness connector terminals to the Engine Control Module (ECM)
(J623)electrical harness connector T94 terminals for resistance.